Nissan Altima 2007-2012 Service Manual: Symptom diagnosis
- None of the power windows can be operated using any switch
- Driver side power window alone does not operate
- Passenger side power window alone does not operate
- Anti-pinch system does not operate normally (driver side)
- Anti-pinch system does not operate normally (passenger side)
- Auto operation does not operate but manual operates normally (driver side)
- Auto operation does not operate but manual operates normally (passenger side)
- Power window retained power operation does not operate properly
- Does not operate by key cylinder switch
- Keyless power window down does not operate
- Power window lock switch does not function
Precaution
Precaution for Supplemental Restraint System
(SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER ...
None of the power windows can be
operated using any switch
Diagnosis Procedure
1. CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
Check BCM power supply and ground circuit.
Refer to BCS-42, "Diagnosis Procedure".
Is the inspection result normal?
...
Other materials:
AMP on signal circuit
Description
When the audio system is turned on, a voltage signal is supplied from the
audio unit to the BOSE speaker
amp. When this signal is received, the BOSE speaker amp. will turn on.
Diagnosis Procedure
1.CHECK AMP ON SIGNAL (BOSE SPEAKER AMP)
1. Turn audio system ON.
2. Check voltag ...
B210F PNP/Clutch interlock switch
Description
IPDM E/R confirms the shift position with the following signals.
• Park/neutral position (PNP) switch
• Shift position signal from BCM (CAN)
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210F is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000 ...
Can communication system
System Description
• CAN communication is a multiplex communication system. This enables the
system to transmit and receive
large quantities of data at high speed by connecting control units with two
communication lines (CAN-H and
CAN-L).
• Control units on the CAN network transmit si ...
