Nissan Altima Owners Manual: Audio system voice commands

To access the audio system voice commands:

1. Press the button.

2. Say “Audio”
3. Speak a command from the following available commands:

● Play (AM, FM, etc.) Allows user to select radio band ● Tune AM (number) Allows user to tune directly to a desired AM frequency
● Tune FM (number) Allows user to tune directly to a desired FM frequency
● SXM channel (number) Allows user to tune directly to a desired SXM station (if so equipped) ● CD Track (number) Allows user to select track to be played ● Play Song (name) Allows user to select song name to be played ● Play Artist (name) Allows user to select artist to be played ● Play Album (name) Allows user to select album name to be played

For more information about the audio system, see “Audio system” in this section.

    Navigation System voice commands
    The following voice commands are available for the Navigation System: ● Street Address (address) ● Points of Interest (name) ● POI by Category ● Home ● Address Book ...

    Information voice commands
    The following voice commands are available for the information functions of the Navigation System: ● Traffic ● Fuel Prices ● Stocks ● Movie Listings ● Current Weath ...

    Other materials:

    P0043, P0044 HO2S3 heater
    Description SYSTEM DESCRIPTION The ECM performs ON/OFF control of the heated oxygen sensor 3 heater corresponding to the engine speed, amount of intake air and engine coolant temperature. OPERATION DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC C ...

    Power distribution system
    System Description INPUT/OUTPUT SIGNAL CHART SYSTEM DESCRIPTION • PDS (POWER DISTRIBUTION SYSTEM) is the system that BCM controls with the operation of the pushbutton ignition switch and performs the power distribution to each power circuit. This system is used instead of the mechanical ...

    TCM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). - TCM - Harnes ...