Nissan Altima Owners Manual: NISSAN Voice Recognition System (if so equipped)
The NISSAN Voice Recognition system allows hands-free operation of the systems equipped on this vehicle, such as the phone and navigation systems.
To operate NISSAN Voice Recognition, press
the button located on the steering
wheel.
When prompted, speak the command for the system you wish to activate. The command given is picked up by the microphone and performed when it is properly recognized. NISSAN Voice Recognition will provide a voice response as well as a message in the center display to inform you of the command results.
- Using the system
- System features
- Bluetooth® Hands-Free Phone System voice commands
- Navigation System voice commands
- Audio system voice commands
- Information voice commands
- My Apps Voice Commands
- Help voice commands
- Troubleshooting guide
Phone settings
To access the phone settings: 1. Press the [ ] button. 2. Select the “Settings” key. 3. Select the “Phone & Bluetooth” key. 4. Select the “Phone Settings” key and adjust the follo ...Using the system
Initialization When the ignition switch is in the ON position, NISSAN Voice Recognition is initialized, which takes a few seconds. When completed, the system is ready to accept voice commands. If ...Other materials:
How to follow trouble diagnoses
Description
NOTICE:
Trouble diagnoses indicate work procedures required to diagnose problems
effectively. Observe the following
instructions before diagnosing.
• Before performing trouble diagnoses, read the “Work Flow” in each section.
• After repairs, re-check that the problem ...
Tweeter (sedan)
Description
The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker
amp. amplifies the audio
signals before sending them to the front tweeters using the audio signal
circuits.
Diagnosis Procedure
1.HARNESS CHECK
1. Disconnect BOSE speaker amp. connector B122 and suspe ...
P0730 belt damage
Description
TCM selects the gear ratio using the engine load (throttle position), the
primary pulley revolution speed, and
the secondary pulley revolution speed as input signal. Then it changes the
operating pressure of the primary
pulley and the secondary pulley and changes the groove width ...