Nissan Altima 2007-2012 Service Manual: Auto operation does not operate but manual operates normally (driver side)

Diagnosis Procedure

1. PERFORM INITIALIZATION PROCEDURE

Perform initialization procedure.

Refer to PWC-21, "POWER WINDOW MAIN SWITCH : Special Repair Requirement".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning parts.

2. CHECK ENCODER

Check encoder.

Refer to PWC-19, "POWER WINDOW MAIN SWITCH : Component Function Check".

Is the inspection result normal? YES >> Inspection End.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Anti-pinch system does not operate normally (driver side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-21, "POWER WINDOW MAIN SWITCH : Special Repair Requirement". Is the inspection ...

    Power window retained power operation does not operate properly
    Diagnosis Procedure 1. CHECK DOOR SWITCH Check door switch. Refer to PWC-32, "Component Function Check". Is the inspection result normal? YES >> Inspection End. NO >> ...

    Other materials:

    M&A branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the combination meter for damage, bend and loose connection (unit side and connector side). ...

    Mainshaft AND Gear
    Exploded View Refer to TM-28, "Exploded View". Disassembly 1. Before disassembling, measure the end play of 1st and 2nd main gears. End play standard value : Refer to TM-83, "End Play". 2. Remove snap ring. 3. Remove C-ring holder and then remove mainshaft C-ring. ...

    Reprogramming a single HomeLink® button
    To reprogram a HomeLink® Universal Transceiver button, complete the following: 1. Press and hold the desired HomeLink® button. DO NOT release the button. 2. The indicator light will begin to flash after 20 seconds. Without releasing the HomeLink® button, proceed with “Programming HomeL ...