Nissan Altima (L32) 2007-2012 Service Manual: Anti-pinch system does not operate
normally (driver side)
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-21, "POWER WINDOW MAIN SWITCH : Special Repair Requirement".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace the malfunctioning parts.
2. CHECK DOOR WINDOW SLIDING PART
• A foreign material adheres to window glass or glass run rubber.
• Glass run rubber wear or deformation.
• Sash is tilted too much or not enough.
Is the inspection result normal?
YES >> GO TO 3
NO >> Repair or replace the malfunctioning parts.
3. CHECK ENCODER CIRCUIT
Check encoder circuit.
Refer to PWC-19, "POWER WINDOW MAIN SWITCH : Component Function Check".
Is the inspection result normal?
YES >> Inspection End.
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Diagnosis Procedure
1. CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH
Check power window and door lock/unlock switch RH.
Refer to PWC-22, "PASSENGER SIDE : Component Function Check" ...
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-21, "POWER WINDOW MAIN SWITCH : Special Repair Requirement".
Is the inspection ...
Other materials: Vehicle identification
Vehicle Identification Number (VIN)
plate
The Vehicle Identification Number (VIN)
plate is attached as shown. This number is
the identification for your vehicle and is
used in the vehicle registration.
Vehicle identification number
(chassis number)
The vehicle identification number is located
as s ...
Chassis Control (if so equipped)
The chassis control is an electric control
module that includes the following functions:
Intelligent Trace Control
Active Ride Control
Intelligent Trace Control (I-TC)
This system senses driving based on the
driver’s steering and acceleration/braking
patterns, and controls brake pressure at
in ...
Continuously Variable Transmission
(CVT)
WARNING
Do not depress the accelerator pedal
while shifting from P (Park) or N (Neutral)
to R (Reverse), D (Drive), L (Low) or
manual shift mode (if so equipped).
Always depress the brake pedal until
shifting is completed. Failure to do so
could cause you to lose control and
have an acciden ...