Nissan Altima (L32) 2007-2012 Service Manual ≻ Lan system can system (type 8) ≻ AV Branch line circuit

Nissan Altima (L32) 2007-2012 Service Manual: AV Branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the AV control unit for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of AV control unit.

2. Check the resistance between the AV control unit harness connector terminals.

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the AV control unit branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the AV control unit. Refer to AV-315, "AV CONTROL UNIT : Diagnosis Procedure".

Is the inspection result normal? YES (Present error)>>Replace the AV control unit. Refer to AV-437, "Removal and Installation".

YES (Past error)>>Error was detected in the AV control unit branch line.

NO >> Repair the power supply and the ground circuit.

A-BAG branch line circuit

Diagnosis Procedure 1.CHECK AIR BAG DIAGNOSIS SENSOR UNIT Check the air bag diagnosis sensor unit. Refer to SRC-3, "Work Flow". Is the inspection result normal? YES >> Replace t ...

BCM branch line circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

Other materials:

Intelligent Driver Alertness (I-DA) system limitations
WARNING Listed below are the system limitations for the I-DA system. Failure to operate the vehicle in accordance with these system limitations could result in serious injury or death. The I-DA system may not operate properly and may not provide an alert in the following conditions: Poor road ...

Voice commands
Voice commands can be used to operate the Bluetooth Hands-Free Phone System. Press and hold thebutton for less than 1.5 seconds to bring up the phone command menu. The commands available are: Call <name> Dial <number> Recent Calls Read/Send Text (if so equipped) Siri (if so equipp ...

LDW system limitations
WARNING Listed below are the system limitations for the LDW system. Failure to follow the warnings and instructions for proper use of the LDW system could result in serious injury or death. The system will not operate at speeds below approximately 37 mph (60 km/h) or if it cannot detect lane ma ...