Nissan Altima 2007-2012 Service Manual: B2605 PNP switch

Description

BCM confirms the shift position with the following 4 signals.

• AT selector lever

• P/N position switch

• P position signal from IPDM E/R (CAN) • P position signal from TCM (CAN)

DTC Logic

DTC DETECTION LOGIC

NOTE: • If DTC B2605 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-36, "DTC Logic".

• If DTC B2605 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-37, "DTC Logic".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON under the following conditions and wait for at least 1 seconds.

- CVT selector lever is in the P or N position

- Do not depress the brake pedal.

2. Check “Self diagnostic result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-86, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.CHECK DTC WITH IPDM E/R

Check “Self diagnostic result” with CONSULT-III. Refer to PCS-45, "DTC Index".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace malfunctioning parts.

2.CHECK PNP SWITCH CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect TCM harness connector and BCM harness connector.

3. Check continuity between TCM connector and BCM harness connector.

4. Check continuity between TCM harness connector and ground.

Is the inspection result normal? YES >> GO TO 3

NO >> Repair harness or connector.

3.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.

    B2604 PNP switch
    Description BCM confirms the shift position with the following 4 signals. • CVT selector lever • P/N position switch • P position signal from IPDM E/R (CAN) • P position signal from TC ...

    B2606 steering lock relay
    Description The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN communication. IPDM E/R turns the steering lock relay ON and transmits the release of the steering to B ...

    Other materials:

    Ignition coil
    Exploded View 1. Ignition coil 2. Spark plug 3. Rocker cover (RH) 4. Rocker cover (LH) Removal and Installation LH REMOVAL 1. Remove engine room cover. 2. Disconnect ignition coil connector. 3. Remove the ignition coil. CAUTION: Never shock ignition coil. INSTALLATION Installatio ...

    Input shaft and gear
    Exploded View Refer to TM-28, "Exploded View". Disassembly 1. Before disassembling, measure end play for 3rd, 4th, 5th, and 6th input gears. End play standard value : Refer to TM-83, "End Play". 2. Remove oil channel. 3. Press out input shaft rear bearing using Tool an ...

    On-vehicle repair
    POWER SOCKET Removal and Installation FRONT POWER SOCKET Removal 1. Remove the instrument panel storage bin or CD changer finisher (if equipped). Refer to IP-17, "Exploded View". 2. Remove the inner socket (1) from the ring (2) while pressing the hooks (B) on the ring (2) out fr ...