Nissan Altima 2007-2012 Service Manual: B2604 PNP switch
Description
BCM confirms the shift position with the following 4 signals.
• CVT selector lever
• P/N position switch
• P position signal from IPDM E/R (CAN)
• P position signal from TCM (CAN)
DTC Logic
DTC DETECTION LOGIC
NOTE: • If DTC B2604 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-36, "DTC Logic".
• If DTC B2604 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-37, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Start the engine under the following conditions and wait for at least 1 seconds.
- CVT selector lever is in the P position
- Do not depress the brake pedal
2. Use CVT selector lever to select each gear one at a time. Wait at each gear for at least 1 second.
3. Check “Self diagnostic result” with CONSULT-III.
Is DTC detected? YES >> Refer to SEC-84, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.CHECK DTC WITH TCM
Check “Self diagnostic result” with CONSULT-III. Refer to TM-221, "DTC Index" (RE0F09B) or TM-399, "DTC Index" (RE0F10A).
Is the inspection result normal? YES >> GO TO 2
NO >> Repair or replace malfunctioning parts.
2.CHECK PNP SWITCH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect TCM harness connector and BCM harness connector.
3. Check continuity between TCM harness connector and BCM harness connector.
4. Check continuity between TCM harness connector and ground.
Is the inspection result normal? YES >> GO TO 3
NO >> Repair harness or connector.
3.CHECK INTERMITTENT INCIDENT
Refer to GI-42, "Intermittent Incident".
>> Inspection End.
B2603 shift position status
Description
BCM confirms the shift position with the following 2 signals.
• CVT selector lever
• P/N position switch
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2603 is displayed wit ...
B2605 PNP switch
Description
BCM confirms the shift position with the following 4 signals.
• AT selector lever
• P/N position switch
• P position signal from IPDM E/R (CAN)
• P position signal from TCM ...
Other materials:
IPDM-E branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose
connection (unit side and connector
side).
- TCM
- Harnes ...
Hands free phone system (sedan)
System Diagram
System Description
Refer to the owner's manual for Bluetooth telephone system operating
instructions.
NOTE:
Cellular telephones must have their wireless connection set up (paired) before
using the Bluetooth telephone
system.
Bluetooth telephone system allows users wh ...
Precautions on child restraints
WARNING
Failure to follow the warnings and instructions
for proper use and installation
of child restraints could result in
serious injury or death of a child or
other passengers in a sudden stop or
collision:
– The child restraint must be used and
installed properly. Always follow all ...