Nissan Altima (L32) 2007-2012 Service Manual: B260A ignition relay

Description

BCM turns ON the following relays to ignition power supply to each ECU when the ignition switch is turned ON.

• Ignition relay-1 (inside IPDM E/R) • Ignition relay-2 (inside fuse box) • Blower fan motor relay

BCM checks any ignition relay ON request for consistency with the actual ignition relay operation status.

DTC Logic

DTC DETECTION LOGIC

NOTE: • If DTC B260A is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to PCS-58, "DTC Logic".

• If DTC B260A is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to PCS-59, "DTC Logic".

• If DTC B260A is displayed with DTC B261A, first perform the trouble diagnosis for DTC B261A. Refer to PCS-75, "DTC Logic".

DTC CONFIRMATION PROCEDURE

1. PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON under the following conditions, and wait for at least 2 seconds.

- CVT selector lever is in the P or N position.

- Release the brake pedal.

2. Check “Self diagnostic result” with CONSULT-III.

Is DTC detected? YES >> Go to PCS-62, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1. CHECK DTC WITH IPDM E/R

Check “Self diagnostic result” with CONSULT-III. Refer to PCS-45, "DTC Index".

Is DTC detected? YES >> Replace IPDM E/R. Refer to PCS-48, "Removal and Installation".

NO >> GO TO 2

2. CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.