Nissan Altima (L32) 2007-2012 Service Manual: B260B steering lock unit
Description
The electronic steering column lock performs the check by itself according to
the steering status.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Press the push-button ignition switch, when steering is locked.
2. Check “Self diagnostic result” with CONSULT-III.
Is DTC detected?
YES >> Refer to SEC-488, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.INSPECTION START
1. Turn ignition switch ON.
2. Check “Self diagnostic result” with CONSULT-III.
3. Touch “ERASE”.
4. Perform DTC Confirmation Procedure.
See SEC-488, "DTC Logic".
Is the DTC B260B displayed again?
YES >> Replace electronic steering column lock.
NO >> Inspection End.
Description
There are 2 switches in the electronic steering column lock (steering
lock/unlock switch 1 and 2). BCM compares
those two switches conditions to judge the present steering status.
DT ...
Description
The electronic steering column lock performs the check by itself according to
the steering status.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRM ...
Other materials: Vehicle security system
The vehicle security system provides visual
and audible alarm signals if someone
opens the doors or trunk when the system
is armed. It is not, however, a motion detection
type system that activates when a vehicle
is moved or when a vibration occurs.
The system helps deter vehicle theft but
cannot p ...
Intelligent Forward Collision Warning (I-FCW)
WARNING
Failure to follow the warnings and instructions
for proper use of the I-FCW
system could result in serious injury or
death.
The I-FCW system can help warn the
driver before a collision occurs but
will not avoid a collision. It is the driver’s
responsibility to stay alert, drive
safel ...
Outside mirrors
The outside mirror remote control only operates
when the ignition switch is placed in
the ON position.
Move the small switch 1 to select the right
or left mirror. Adjust each mirror to the desired
position using the large switch 2.
Move the small switch 1 to the center
(neutral) position to preve ...