Nissan Altima 2007-2012 Service Manual: Component diagnosis
- U1000 can comm circuit
- U1010 control unit (can)
- B2013 ID discord, immu-strg
- B2014 chain of strg-immu
- B2108 steering lock relay
- B2109 steering lock relay
- B210A steering lock condition switch
- B210B starter control relay
- B210C starter control relay
- B210D starter relay
- B210E starter relay
- B210F PNP/Clutch interlock switch
- B2110 PNP/Clutch interlock switch
- B2190, P1610 nats antenna amp
- B2191, P1615 Difference of key
- B2192, P1611 ID discord, immu-ecm
- B2193, P1612 chain of ECM-IMMU
- B2555 stop lamp
- B2556 push-button ignition switch
- B2557 vehicle speed
- B2560 starter control relay
- B2601 shift position
- B2602 shift position
- B2603 shift position status
- B2604 PNP switch
- B2605 PNP switch
- B2606 steering lock relay
- B2607 steering lock relay
- B2608 starter relay
- B2609 steering status
- B260B steering lock unit
- B260C steering lock unit
- B260D steering lock unit
- B260F engine status
- B2612 steering status
- B2617 starter relay circuit
- B2619 BCM
- B261A push-button ignition switch
- B26e1 no reception of engine status signal
- Power supply and ground circuit
- IPDM E/R (Intelligent power distribution module engine room)
- Key slot
- Key slot illumination
- Key cylinder switch
- Horn
- Headlamp
- Warning lamp
- Vehicle security indicator
Diagnosis system (BCM)
COMMON ITEM
Diagnosis Description
BCM CONSULT-III FUNCTION
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functi ...
U1000 can comm circuit
Description
CAN (Controller Area Network) is a serial communication line for real time
applications. It is an on-vehicle multiplex
communication line with high data communication speed and excell ...
Other materials:
On-vehicle repair
WHEEL HUB
Removal and Installation
1. Knuckle
2. Baffle plate
3. Wheel hub assembly
4. Brake rotor
5. Wheel nut
6. Anchor block
7. ABS sensor
8. Parking brake cable
A. Refer to PB-6, "PEDAL TYPE : Exploded View" (Pedal type), PB-7, "LEVER
TYPE : Exploded View" (Leve ...
BCM branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the BCM for damage, bend and loose
connection (unit side and
connector side).
Is the inspec ...
NISSAN vehicle immobilizer system
The NISSAN Vehicle Immobilizer System will not
allow the engine to start without the use of a
registered key.
Never leave these keys in the vehicle.
FCC Notice:
For USA:
This device complies with part 15 of the
FCC Rules. Operation is subject to the following
two conditions: (1) This devic ...