Nissan Altima (L32) 2007-2012 Service Manual: B260d steering lock unit
Description
The electronic steering column lock performs the check by itself according to
the steering lock status (before
lock, after lock and unlock).
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Turn ignition switch OFF.
3. Press door switch.
4. Check “Self diagnostic result” with CONSULT-III.
Is DTC detected?
YES >> Refer to SEC-99, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.INSPECTION START
1. Turn ignition switch ON.
2. Check “Self diagnostic result” with CONSULT-III.
3. Touch “ERASE”.
4. Perform DTC Confirmation Procedure.
See SEC-99, "DTC Logic".
Is the DTC B260D displayed again?
YES >> Replace electronic steering column lock.
NO >> Inspection End.
Description
The electronic steering column lock performs the check by itself according to
the steering status.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRM ...
Description
BCM receives the engine status signal from ECM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B260F is displayed with DTC U1000, first perform the trouble dia ...
Other materials: Changing engine oil and oil filter
For additional information on engine oil
and oil filter change, refer to the instructions
outlined in this section.
Vehicle set-up
1. Park the vehicle on a level surface and
apply the parking brake.
2. Run the engine until it reaches operating
temperature.
3. Turn the engine off and wait for 15 mi ...
Engine compartment check locations
2.0L 4 cylinder (KR20DDET engine model)
Engine coolant reservoir
Drive belt location
Engine oil filler cap
Brake fluid reservoir
Battery
Fuse/Fusible link box
Air cleaner
Radiator cap
Engine oil dipstick
Windshield-washer fluid reservoir
Refer to the page number indicated in
parenth ...
System temporarily unavailable
Condition A:
The warning and assist functions of the I-LI
system are not designed to work under the
following conditions:
When you operate the lane change signal
and change the traveling lanes in the direction
of the signal. (The I-LI system
will be deactivated for approximately 2
seconds afte ...