Nissan Altima (L32) 2007-2012 Service Manual ≻ Security control system sedan with intelligent key ≻ Component diagnosis ≻ B260D steering lock unit

Nissan Altima (L32) 2007-2012 Service Manual: B260D steering lock unit

Description

The electronic steering column lock performs the check by itself according to the steering lock status (before lock, after lock and unlock).

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Turn ignition switch OFF.

3. Press door switch.

4. Check “Self diagnostic result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-298, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Check “Self diagnostic result” with CONSULT-III.

3. Touch “ERASE”.

4. Perform DTC Confirmation Procedure.

See SEC-298, "DTC Logic".

Is the DTC B260D displayed again? YES >> Replace electronic steering column lock.

NO >> Inspection End.

B260C steering lock unit

Description The electronic steering column lock performs the check by itself according to the steering status. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMA ...

B260F engine status

Description BCM receives the engine status signal from ECM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B260F is displayed with DTC U1000, first perform the trouble dia ...

Other materials:

NISSAN Vehicle Immobilizer System
The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of a registered key. If the engine fails to start using a registered key (for example, when interference is caused by another registered key, an automated toll road device or automatic payment device on the key ...

NISSAN Intelligent Key Operation
You can lock or unlock the doors and trunk lid without taking the Intelligent Key out of your pocket or bag. When you carry the Intelligent Key with you, you can lock or unlock all doors and trunk lid by pushing the door handle request switch (if so equipped) within the range of operation. Lockin ...

RearView Monitor system operation
With the ignition switch in the ON position, move the shift lever to the R (Reverse) position to operate the RearView Monitor. How to read the displayed lines Guiding lines which indicate the vehicle width and distances to objects with reference to the vehicle body line A are displayed on the monit ...