Nissan Altima 2007-2012 Service Manual: Component diagnosis
- U1000 can comm circuit
- U1010 control unit (can)
- B2013 ID discord, immu-strg
- B2014 chain of strg-immu
- B2108 steering lock relay
- B2109 steering lock relay
- B210a steering lock condition switch
- B210b starter control relay
- B210C starter control relay
- B210D starter relay
- B210E starter relay
- B210F PNP/clutch interlock switch
- B2110 PNP/clutch interlock switch
- B2190, P1610 nats antenna AMP
- B2191, P1615 difference of key
- B2192, P1611 ID discord, IMMU-ECM
- B2193, P1612 chain of ECM-IMMU
- B2555 stop lamp
- B2556 push-button ignition switch
- B2557 vehicle speed
- B2560 starter control relay
- B2601 shift position
- B2602 shift position
- B2603 shift position status
- B2604 PNP switch
- B2605 PNP switch
- B2606 steering lock relay
- B2607 steering lock relay
- B2608 starter relay
- B2609 steering status
- B260B steering lock unit
- B260C steering lock unit
- B260D steering lock unit
- B260F engine status
- B2612 Steering status
- B2617 Starter relay circuit
- B2619 BCM
- B261A push-button ignition switch
- B26E1 No reception of engine status signal
- POWER supply and ground circuit
- Key slot
- Key slot illumination
- Key cylinder switch
- Horn
- Headlamp
- Warning lamp
- Vehicle security indicator
Diagnosis system (BCM)
COMMON ITEM
Diagnosis Description
CONSULT-III performs the following functions via CAN communication with
BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NO ...
U1000 can comm circuit
DescriptionCAN (Controller Area Network) is a serial communication
line for real time applications. It is an on-vehicle multiplex
communication line with high data communication speed and excellent ...
Other materials:
Cooling fan control
System Diagram
System Description
INPUT/OUTPUT SIGNAL CHART
*1: The ECM determines the start signal status by the signals of engine speed
and battery voltage.
*2: This signal is sent to ECM via the CAN communication line.
SYSTEM DESCRIPTION
The ECM controls the cooling fan correspondin ...
P1722 estm vehicle speed signal
Description
The vehicle speed signal is transmitted from ABS actuator and electric unit
(control unit) to TCM by CAN communication
line.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If “DTC CONFIRMATION PROCEDURE” ha ...
Receiving a call
When a call is placed to the connected phone,
the display will change to phone mode.
To accept the incoming call, either:
● Press the button on the
steering
wheel, or
● Touch the icon on the screen.
To reject the incoming call, either:
● Press the button on the steer ...