Nissan Altima Owners Manual: BSW driving situations

Another vehicle approaching from behind

The Blind spot indicator light illuminates if a vehicle


The Blind spot indicator light illuminates if a vehicle enters the detection zone from behind in an adjacent lane.

However, if the overtaking vehicle is traveling much faster than your vehicle, the indicator light may not illuminate before the detected vehicle is beside your vehicle. Always use the side and rear mirrors and turn and look in the direction your vehicle will move to ensure it is safe to change lanes.

If the driver activates the turn signal, then the


If the driver activates the turn signal, then the Blind Spot indicator light flashes and a chime will sound twice.

NOTE:

If the driver activates the turn signal before a vehicle enters the detection zone, the Blind Spot indicator light will flash but no chime will sound when the other vehicle is detected.

Overtaking other vehicles


Overtaking other vehicles

The Blind Spot indicator light illuminates if you overtake a vehicle and that vehicle stays in the detection zone for approximately 3 seconds.

The camera unit may not detect slower moving vehicles if they are passed quickly.

If the driver activates the turn signal while another


If the driver activates the turn signal while another vehicle is in the detection zone, then the Blind Spot indicator light flashes and a chime will sound twice.

LDW system operation


    BSW system operation
    The BSW system operates above approximately 20 MPH (32 km/h). When the camera unit detects vehicles in the detection zone, the Blind spot indicator light located inside the outside mirrors wil ...

    LDW system operation
    The LDW system operates above approximately 45 MPH (70 km/h). When the vehicle approaches either the left or the right of the traveling lane, the LDW system will chime a sound and the LDW light ...

    Other materials:

    P0031, P0032 A/F sensor 1 heater
    Description SYSTEM DESCRIPTION The ECM performs ON/OFF duty control of the A/F sensor 1 heater corresponding to the engine operating condition to keep the temperature of A/F sensor 1 element at the specified range. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITI ...

    C1712 - C1715, C1720 - C1723, C1724 -C1727 Transmitter malfunction
    Description One or more transmitters are malfunctioning internally. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.DRIVE VEHICLE 1. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes. 2. Check all tire pressu ...

    Power consumption control system
    System Diagram System Description OUTLINE • IPDM E/R incorporates a power consumption control function that reduces the power consumption according to the vehicle status. • IPDM E/R changes its status (control mode) with the sleep wake up signal received from BCM via CAN communicat ...