Nissan Altima Owners Manual: Starting and driving
- Precautions when starting and driving
- Exhaust gas (carbon monoxide)
- Three-way catalyst
- Tire Pressure Monitoring System (TPMS)
- Avoiding collision and rollover
- Off-road recovery
- Rapid air pressure loss
- Drinking alcohol/drugs and driving
- Push-Button Ignition Switch
- Operating range
- Push-button ignition switch positions
- Emergency engine shut off
- NISSAN Intelligent Key® battery discharge
- NISSAN vehicle immobilizer system
- Before starting the engine
- Starting the engine
- Driving the vehicle
- Parking brake
- Blind Spot Warning (BSW) System / Lane Departure Warning (LDW) System (if so equipped)
- BSW system operation
- BSW driving situations
- LDW system operation
- BSW/LDW temporary disabled status
- BSW/LDW automatic deactivation
- Camera unit maintenance
- Cruise control (if so equipped)
- Break-in schedule
- Fuel efficient driving tips
- Increasing fuel economy
- Parking/parking on hills
- Power steering
- Brake system
- Vehicle Dynamic Control (VDC) system
- Cold weather driving
Troubleshooting guide
The system should respond correctly to all voice
commands without difficulty. If problems are encountered,
follow the solutions given in this guide
for the appropriate error. Where the solutions ar ...
Precautions when starting and driving
WARNING
● Do not leave children or adults who
would normally require the assistance
of others alone in your vehicle. Pets
should also not be left alone. They
could accidentally injure thems ...
Other materials:
High-pressure flexible hose
Removal and Installation for High-Pressure Flexible
Hose
QR25DE
Removal
1. Discharge the refrigerant. Refer to HA-32, "HFC-134a (R-134a) Service
Procedure".
2. Reposition the power steering reservoir out of the way without disconnecting
the hose.
3. Reposition the engine coo ...
License lamp finisher
Removal and Installation
1. License lamp finisher
REMOVAL
1. Remove the trunk lid finisher (if equipped). Refer to INT-23, "Removal and
Installation".
2. Remove the license lamp finisher nuts.
3. Remove license lamp finisher by pulling toward the rear, then disconnect the
tr ...
Rear speaker
Description
The audio unit sends audio signals to the rear speakers using the rear
speaker circuits.
Diagnosis Procedure
1.HARNESS CHECK
1. Disconnect audio unit connector M43 (A) and suspect speaker
connector.
2. Check continuity between audio unit harness connector M43 (A)
and suspect ...