Nissan Altima Owners Manual: BSW/LDW automatic deactivation

When dirt, rain or snow cannot be removed by the automatic washer and blower and accumulates on the camera, making it impossible to detect the vehicles or the lane markers, the BSW and/or LDW system will be turned off automatically.

The BSW light (white) and/or LDW light (white) will blink, and the “Unavailable : Clean rear camera” will appear in the vehicle information display.

Action to take:

If the message appears, park the vehicle in a safe place, clean the camera unit with a soft cloth.

Then turn off and restart the engine.

When the BSW and/or LDW system malfunctions, they will be turned off automatically, the BSW light (orange) and/or LDW light (orange) will illuminate and “Malfunction: Please see owners manual” will appear in the vehicle information display.

Action to take:

Stop the vehicle in a safe location, turn off and restart the engine. If the BSW light (orange) and/or the LDW light (orange) continues to illuminate, have the BSW and/or LDW system checked by a NISSAN dealer.

    BSW/LDW temporary disabled status
    Under the following condition, the BSW and/or LDW system is turned off temporarily, the BSW light (white) and/or LDW light (white) will blink, and either of the following message will appear in th ...

    Camera unit maintenance
    The rear camera unit 1 for the LDW/BSW systems is located above the rear licence plate. To maintain the proper operation of the LDW/BSW systems and help keep the system functioning, be sure to o ...

    Other materials:

    B2601 shift position
    Description BCM confirms the shift position with the following 2 signals. • CVT selector lever • P position signal from IPDM E/R (CAN) DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2601 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-36 ...

    Condenser
    Removal and Installation - Coupe REMOVAL 1. Remove the rear seat cushion and the rear seatback. Refer to SE-25, "Removal and Installation". 2. Remove the rear kicking plate, rear wheel well garnish and the rear pillar finisher. Refer to INT-19, "Removal and Installation&q ...

    Front wiper ARMS
    Removal and Installation REMOVAL 1. Turn wiper switch ON to operate wiper motor, and then turn wiper switch OFF (auto stop). 2. Open hood, remove arm caps, and remove wiper arm nuts. 3. Raise wiper arm, and remove wiper arm from the vehicle. INSTALLATION 1. Clean up the pivot area as sho ...