Nissan Altima (L32) 2007-2012 Service Manual: C1729 vehicle speed signal
Description
The vehicle speed signal is not being detected by the BCM.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAGNOSTIC RESULTS
1. On SELECT DIAG MODE, select the SELF-DIAG RESULT screen.
2. Check display contents on SELF DIAG RESULT screen.
Is the CAN COMM CIRCUIT displayed in the self-diagnosis display? YES >> Refer to WT-19, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
MALFUNCTION CODE NO. 52 (DTC C1729)
1.CHECK SELF-DIAGNOSTIC RESULTS
1. On “SELECT DIAG MODE”, select the “SELF-DIAG RESULT” screen.
2. Check display contents on “SELF DIAG RESULT” screen.
Is the “CAN COMM CIRCUIT” displayed in the self-diagnosis display? YES >> Perform trouble diagnosis for CAN communication system. Refer to LAN-25, "CAN System Specification Chart".
NO >> Check combination meter. Refer to MWI-38, "CONSULT-III Function (METER/M&A)".
Special Repair Requirement
Perform preliminary check. Refer to WT-5, "Preliminary Check".
C1716 - C1719 Transmitter pressure malfunction
Description Air pressure data from one or more transmitters is out of range. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.ID REGISTRATION AND VEHICLE DRIVING 1. Carry out ID reg ...C1734 control unit
Description An internal malfunction has been detected in the TPMS function of the BCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAGNOSTIC RESULTS 1. On SELECT DI ...Other materials:
Cup holders
Front
Rear
The rear center cup holders are located in the
rear fold-down armrest.
CAUTION
● Avoid abrupt starting and braking when
the cup holder is being used to prevent
spilling the drink. If the liquid is hot, it
can scald you or your passenger.
● Use only soft cups in th ...
Warning signals
To help prevent the vehicle from moving unexpectedly
by erroneous operation of the Intelligent
Key or to help prevent the vehicle from being
stolen, a chime or buzzer sounds from inside and
outside the vehicle and a warning is displayed in
the instrument panel.
When a chime or beep sounds or ...
P0442 evap control system
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P0442 is displayed with DTC P0456, first perform the trouble diagnosis
for DTC P0456. Refer to
EC-841, "DTC Logic".
This diagnosis detects leaks in the EVAP purge line using engine intake manifold
vacuum.
If pressure does not increa ...