Nissan Altima 2007-2012 Service Manual: Camera on signal circuit (coupe)
Description
When the selector lever is placed in the R position, the rear view camera control unit sends a camera ON signal to the rear view camera.
Diagnosis Procedure
1.CHECK CAMERA ON SIGNAL CIRCUIT CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect rear view camera control unit connector and rear view camera connector.
3. Check continuity between rear view camera control unit harness connector B31 (A) terminal 8 and rear view camera harness connector T7 (B) terminal 1.
4. Check continuity between rear view camera control unit harness connector B31 (B) terminal 8 and ground.
Is inspection result OK? YES >> GO TO 2
NO >> Repair harness or connector.
2.CHECK CAMERA ON SIGNAL VOLTAGE
1. Connect rear view camera control unit connector and rear view camera connector.
2. Turn ignition switch ON.
3. Check voltage between rear view camera control unit harness connector B31 terminal 8 and ground.
Is inspection result OK? YES >> Replace rear view camera. Refer to AV-457, "Removal and Installation".
NO >> Replace rear view camera control unit. Refer to AV-458, "Removal and Installation - Coupe".
Camera image signal circuit (rear view camera to camera control unit)(sedan)
Description Rear view camera images are transmitted to the rear view camera control unit using the camera image signal circuits. Diagnosis Procedure 1.CHECK CAMERA IMAGE SIGNAL CIRCUIT CONTINU ...Camera on signal circuit (sedan)
Description When the selector lever is placed in the R position, the rear view camera control unit sends a camera ON signal to the rear view camera. Diagnosis Procedure 1.CHECK CAMERA ON SIGNAL ...Other materials:
Front door glass
Components
1. Door
2. Inside seal
3. Door glass
4. Regulator assembly
5. Door module assembly
6. Window motor
7. Cover
Removal and Installation
REMOVAL
1. Remove the front door finisher. Refer to INT-12, "Removal and
Installation".
2. Remove the bolt hole covers.
3. R ...
Information display
System Diagram
System Description
FUNCTION
The information display can indicate the following items.
• Outside air temperature
• Trip/fuel consumption readings
• Intelligent Key operation information
• Maintenance information
• Warning/Indication messages (Door ajar, low fuel, ...
Oil seal
Removal and Installation of Valve Oil Seal
REMOVAL
1. Turn crankshaft until the cylinder requiring new oil seals is at TDC. This
will prevent valve from dropping
into cylinder.
CAUTION:
When rotating crankshaft, be careful to avoid scarring the front cover with the
timing chain.
2. Remove ...