Nissan Altima 2007-2012 Service Manual: Camera on signal circuit (sedan)

Description

When the selector lever is placed in the R position, the rear view camera control unit sends a camera ON signal to the rear view camera.

Diagnosis Procedure

1.CHECK CAMERA ON SIGNAL CIRCUIT CONTINUITY

1. Turn ignition switch OFF.

2. Disconnect rear view camera control unit connector and rear view camera connector.

3. Check continuity between rear view camera control unit harness connector B31 (A) terminal 8 and rear view camera harness connector B35 (B) terminal 1.

4. Check continuity between rear view camera control unit harness connector B31 (B) terminal 8 and ground.

Is inspection result OK? YES >> GO TO 2

NO >> Repair harness or connector.

2.CHECK CAMERA ON SIGNAL VOLTAGE

1. Connect rear view camera control unit connector and rear view camera connector.

2. Turn ignition switch ON.

3. Check voltage between rear view camera control unit harness connector B31 terminal 8 and ground.

Is inspection result OK? YES >> Replace rear view camera. Refer to AV-457, "Removal and Installation".

NO >> Replace rear view camera control unit. Refer to AV-458, "Removal and Installation - Sedan".

    Camera on signal circuit (coupe)
    Description When the selector lever is placed in the R position, the rear view camera control unit sends a camera ON signal to the rear view camera. Diagnosis Procedure 1.CHECK CAMERA ON SIGNAL ...

    Camera image signal circuit (camera control unit to av control unit)
    Description Rear view camera image signals are transmitted from the rear view camera control unit to the AV control unit using the image signal circuits. Diagnosis Procedure 1.CHECK CAMERA IMAG ...

    Other materials:

    Both side front fog lamps are not turned on
    Description The front fog lamps do not turn ON in any setting. Diagnosis Procedure 1.COMBINATION SWITCH INSPECTION Check the combination switch. Refer to BCS-10, "System Description". Is the combination switch normal? YES >> GO TO 2 NO >> Repair or replace the malfunc ...

    P0011 IVT Control
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0011 is displayed with DTC P0075, first perform the trouble diagnosis for EC-867, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF ...

    Rear speaker
    Removal and Installation - Coupe REMOVAL 1. Remove the trunk front finisher. Refer to INT-23, "Removal and Installation". 2. Remove the rear speaker screws (A), then disconnect the rear speaker connector (B) and remove the rear speaker (1). INSTALLATION Installation is in the ...