Nissan Altima Owners Manual: Checking bulbs

With all doors closed, apply the parking brake and place the ignition switch to the ON position without starting the engine. The following lights will come on:

The following lights (if equipped) come on briefly


The following lights (if equipped) come on briefly and then go off:

If any light fails to come on, it may indicate


If any light fails to come on, it may indicate a burned-out bulb or an open circuit in the electrical system. Have the system repaired promptly.

    Warning lights
    For additional information on warnings and indicators, see “Vehicle information display” later in this section. Anti-lock Braking System (ABS) warning light When the ignition switch is plac ...

    Other materials:

    ECM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). - ECM - Harnes ...

    Disassembly and assembly
    FRONT DRIVE SHAFT Disassembly and Assembly (Left Side) 1. Circlip 2. Dust shield 3. Slide joint housing 4. Snap ring 5. Spider assembly 6. Stopper ring 7. Boot band 8. Boot 9. Shaft 10. Damper band 11. Damper 12. Boot band 13. Boot 14. Ball cage / Steel ball / Inner race assembly ...

    Ground
    Ground Distribution MAIN HARNESS ENGINE ROOM HARNESS FRONT END MODULE HARNESS ENGINE CONTROL HARNESS BODY HARNESS BODY NO. 2 HARNESS HARNESS Harness Layout HOW TO READ HARNESS LAYOUT The following Harness Layouts use a map style grid to help locate connectors on the draw ...