Nissan Altima 2007-2012 Service Manual: Diagnosis system (BCM)

COMMON ITEM

Diagnosis Description

BCM CONSULT-III FUNCTION

CONSULT-III performs the following functions via CAN communication with BCM.

SYSTEM APPLICATION

BCM can perform the following functions for each system.

NOTE: It can perform the diagnosis modes except the following for all sub system selection items.

CONSULT-III Function

ECU IDENTIFICATION

Displays the BCM part No.

SELF-DIAG RESULT

Refer to BCS-91, "DTC Index".

INTELLIGENT KEY

 CONSULT-III Function (BCM - INTELLIGENT KEY)

WORK SUPPORT

SELF-DIAG RESULT

Refer to BCS-91, "DTC Index".

DATA MONITOR

ACTIVE TEST

THEFT ALM

 CONSULT-III Function (BCM - THEFT ALM)

WORK SUPPORT

DATA MONITOR

ACTIVE TEST

IMMU

CONSULT-III Function (BCM - IMMU)

DATA MONITOR

ACTIVE TEST

    Vehicle security system
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART OPERATION FLOW SETTING THE VEHICLE SECURITY SYSTEM Initial Condition • Ignition switch is in OFF position. Disarmed Phase †...

    Other materials:

    Water pump
    Removal and Installation 1. Water pump 2. O-rings WARNING: Never remove the radiator cap when the engine is hot. Serious burns could occur from high pressure coolant escaping from the radiator. CAUTION: • When removing water pump assembly, be careful not to get coolant on drive belt. ...

    Multiport fuel injection system
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: This sensor is not used to control the engine system under normal conditions. *2: This signal is sent to the ECM through CAN communication line. *3: ECM determines the start signal status by the signals of engine speed and ...

    TCM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). - TCM - Harnes ...