Nissan Altima (L32) 2007-2012 Service Manual: Disassembly and assembly
TORQUE CONVERTER AND CONVERTER
HOUSING OIL SEAL
Exploded View
1. CVT assembly
2. Converter housing oil seal
3. Torque converter
Apply CVT Fluid. Refer to MA-12,
"Fluids and Lubricants".
Disassembly
1. Remove torque converter.
2. Remove the converter housing oil seal using suitable tool.
CAUTION:
Do not scratch converter housing.
Assembly
1. Drive the converter housing oil seal in evenly using suitable tool.
CAUTION:
• Do not reuse converter housing oil seal.
• Apply CVT fluid to converter housing oil seal.
2. Install the torque converter.
TRANSAXLE ASSEMBLY
Exploded View
1. Air breather hose
2. CVT fluid level gauge
3. CVT fluid charging pipe
4. O-ring
5. Copper washer
6. Fluid cooler tube
7. Fluid cooler tube
8. CVT assemb ...
General Specification
CAUTION:
• Use only Genuine NISSAN CVT Fluid NS-2. Do not mix with other fluid.
• Using CVT fluid other than Genuine NISSAN CVT Fluid NS-2 will deteriorate in
drivea ...
Other materials: Avoiding collision and rollover
WARNING
Failure to operate this vehicle in a safe
and prudent manner may result in loss
of control or an accident.
Be alert and drive defensively at all times.
Obey all traffic regulations. Avoid excessive
speed, high speed cornering, or sudden
steering maneuvers, because these driving
practices co ...
Intelligent Driver Alertness system
operation
For vehicles with the 7 inch (18 cm)
display
For vehicles with the 5 inch (13 cm)
display
If the system detects driver fatigue or that
driver attention is decreasing, the message
"Take a break?" appears in the vehicle
information display and a chime sounds
when the vehicle is driven at speeds abov ...
Steering Assist temporary
standby
Automatic standby due to driving
operation:
When the driver activates the turn signal,
the Steering Assist is temporarily placed in
a standby mode. (The Steering Assist restarts
automatically when the operating
conditions are met again.)
Automatic standby:
In the following cases, a warning message
i ...