Nissan Altima 2007-2012 Service Manual: Service data and specifications (SDS)
General Specification
CAUTION: • Use only Genuine NISSAN CVT Fluid NS-2. Do not mix with other fluid.
• Using CVT fluid other than Genuine NISSAN CVT Fluid NS-2 will deteriorate in driveability and CVT durability, and may damage the CVT, which is not covered by the NISSAN new vehicle limited warranty.
*1: Refer to MA-12, "Fluids and Lubricants".
Vehicle Speed When Shifting Gears
Numerical value data are reference values.
CAUTION: Lock-up clutch is engaged when vehicle speed is approximately 18 km/h (11 MPH) to 90 km/h (56 MPH).
Stall Speed
Line Pressure
Solenoid Valves
CVT Fluid Temperature Sensor
Primary Speed Sensor
Secondary Speed Sensor
Removal and Installation
Disassembly and assembly
TORQUE CONVERTER AND CONVERTER
HOUSING OIL SEAL
Exploded View
1. CVT assembly
2. Converter housing oil seal
3. Torque converter
Apply CVT Fluid. Refer to MA-12,
"Fluids and Lubricants& ...
Front Axle
...
Other materials:
Precaution
Precaution for Supplemental Restraint System
(SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
dr ...
B210a steering lock condition switch
Description
There are 2 switches in the steering unit. IPDM E/R compares those 2 switches
conditions to judge the
present steering status and transmit the result to BCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210A is displayed with DTC U1000, first perform the ...
M&A branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the combination meter for damage, bend
and loose connection
(unit side and connector side).
...