Nissan Altima 2007-2012 Service Manual: Disassembly and assembly
Cylinder head
Removal and Installation 1. Cylinder head 2. Cylinder head gasket 3. Cylinder head bolt A. Follow installation procedure REMOVAL 1. Remove the engine and transaxle assembly. Refer to EM-72, ...Cylinder block
Disassembly and Assembly 1. Cylinder block 2. O-ring 3. Crankshaft position sensor (POS) 4. Knock sensor 5. Cylinder block heater (if equipped) 6. Lower cylinder block 7. Lower cylinder bloc ...Other materials:
B210D starter relay
Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned
ON by the BCM when the ignition
switch is in START position. IPDM E/R transmits the starter relay ON signal to
BCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210D is display ...
P0448 evap canister vent control
valve
Description
The EVAP canister vent control valve is located on the EVAP canister
and is used to seal the canister vent.
This solenoid valve responds to signals from the ECM. When the
ECM sends an ON signal, the coil in the solenoid valve is energized.
A plunger will then move to seal the c ...
Fuel injector
Description
The fuel injector is a small, precise solenoid valve. When the ECM
supplies a ground to the fuel injector circuit, the coil in the fuel injector
is energized. The energized coil pulls the ball valve back and
allows fuel to flow through the fuel injector into the intake manifold.
...