Nissan Altima 2007-2012 Service Manual: Door finisher
Exploded View
1. Power window switch finisher
2. Front door finisher
3. Step lamp
4. Armrest finisher
5. Inside release handle escutcheon
6. Inside release handle
Removal and Installation
Removal
1. Release the pawls at the rear edge and remove inside release handle escutcheon, then remove the screw.
2. Lift power window and door lock/unlock switch finisher upward to remove, then disconnect the connectors.
• Remove the front door finisher screw beneath power window and door lock/unlock switch finisher.
3. Place a suitable tool (A) under the rear corner of the armrest finisher (1) and disengage the bottom plastic clips. Slide the tool up to disengage the three metal clips.
CAUTION: Do not pull on the armrest finisher.
4. Continue to move the suitable tool (A) and disengage the upper metal clip and remove armrest finisher (1).
5. Remove the front door finisher screw beneath armrest finisher.
6. Release the clips around outer edge, then remove front door finisher.
7. Disconnect inside release handle and lock knob cables from back of front door finisher.
Installation
Installation is in the reverse order of removal.
Body side trim
Exploded View
1. Front pillar finisher
2. Front body side welt
3. Front kicking plate
4. Front sill cover
5. Rear lower finisher
6. Upper pillar finisher
7. Rear pillar finisher
Removal ...
Other materials:
Precaution
Supplemental Restraint System (SRS) "AIR BAG"
and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and front ...
P0075, P0081 IVT control solenoid
valve
Description
Intake valve timing control solenoid valve is activated by ON/OFF
pulse duty (ratio) signals from the ECM.
The intake valve timing control solenoid valve changes the oil
amount and direction of flow via the intake valve timing control unit
or stops oil flow.
The longer pulse w ...
Roof side molding
Removal and Installation
1. Body side outer panel
2. Windshield
2. Windshield
REMOVAL
1. Lift and twist the roof side molding up from the rear edge.
2. Disconnect the roof side molding from the clips, and remove the roof side
molding.
INSTALLATION
Installation is in the reverse or ...