Nissan Altima 2007-2012 Service Manual: Door switch

Description

Detects door open/close condition and transmits the signal to BCM.

Component Function Check

1. CHECK FRONT DOOR SWITCH INPUT SIGNAL

Check (“DOOR SW-DR” and “DOOR SW-AS”) in “DATA MONITOR” mode with CONSULT-III. Refer to BCS- 34, "RETAINED PWR : CONSULT-III Function (BCM - RETAINED PWR)".

Is the inspection result normal? YES >> Front door switch circuit is OK.

NO >> Refer to PWC-326, "Diagnosis Procedure".

Diagnosis Procedure

1. CHECK HARNESS CONTINUITY

Check voltage between BCM connector and ground.

Is the measurement value within the specification? YES >> Replace BCM. Refer to BCS-96, "Removal and Installation".

NO >> GO TO 2

2. CHECK HARNESS CONTINUITY

1. Turn ignition switch OFF.

2. Disconnect BCM and front door switch.

3. Check continuity between BCM connector (A) and front door switch connector (B).

4. Check continuity between BCM connector (A) and ground.

Is the inspection result normal? YES >> GO TO 3

NO >> Repair or replace harness.

3. CHECK BCM OUTPUT SIGNAL

1. Connect BCM connector.

2. Check voltage between BCM connector and ground.

Is the measurement value within the specification? YES >> GO TO 4

NO >> Replace BCM. Refer to BCS-96, "Removal and Installation".

4. CHECK FRONT DOOR SWITCH

Check front door switch.

Refer to PWC-327, "Component Inspection".

Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> Replace front door switch.

Component Inspection

1. CHECK FRONT DOOR SWITCH

Check front door switches.

Is the inspection result normal? YES >> Front door switch is OK.

NO >> Replace front door switch.

    Passenger side
    Description Detects condition of the front power window motor RH operation and transmits to power window and door lock/unlock switch RH as pulse signal. Component Function Check 1.CHECK ENCODER ...

    Door key cylinder switch
    Description Power window main switch detects condition of the door key cylinder and transmits to BCM as the LOCK or UNLOCK signals. Component Function Check 1. CHECK DOOR KEY CYLINDER SWITCH IN ...

    Other materials:

    Periodic maintenance
    Introduction of Periodic Maintenance Two different maintenance schedules are provided, and should be used, depending upon the conditions in which the vehicle is mainly operated. After 60,000 miles (96,000 km) or 48 months, continue the periodic maintenance at the same mileage/time intervals. ...

    Intake sensor
    Description Intake Sensor The intake sensor is located on the heater and cooling unit. It converts temperature of air after it passes through the evaporator into a resistance value which is then input to the front air control. Diagnosis Procedure SYMPTOM: Intake sensor circuit is open or ...

    ECM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). - ECM - Harnes ...