Nissan Altima Owners Manual: During a call
While a call is active, press the
button to
access additional options. Speak one of the following
commands:
● “Send” – Speak this command followed by the digits to enter digits during the phone call.
● “Mute On” or “Mute Off” – Speak the command to mute or unmute the system.
● “Transfer Call” – Speak this command to
transfer the call to the handset. To transfer
the call back from the handset to the
Bluetooth® Hands-Free Phone System,
press the button and confirm
when
prompted.
If supported by the phone, the Bluetooth®
Hands-Free Phone System allows for call waiting
functionality. If a call is received while another call
is already active, a message will be displayed on
the screen. Press the button to
hold the
active call and switch to the second call. Press
the button to reject the second
call.
While the second call is active, pressing
the button will allow the same
commands
that available during any call as well as two additional
commands:
● “Switch Call” – Speak this command to hold the second call and switch back to the original call.
● “End Other Call” – Speak this command to stay with the second call and end the original call.
Press the button to accept the
call. Press
the button to reject the call.
Receiving a call
When a call is received by the phone connected
to the vehicle’s Bluetooth® Hands-Free Phone
System, the call information is displayed on either
the vehicle information display or both the vehicl ...
Ending a call
To end an active call, press the
button. ...
Other materials:
P0452 evap control system pressure
sensor
Description
The EVAP control system pressure sensor detects pressure in the
purge line. The sensor output voltage to the ECM increases as pressure
increases.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously cond ...
Parking lamp circuit
Description
The IPDM E/R (intelligent power distribution module engine room) controls the
tail lamp relay based on inputs
from the BCM over the CAN communication lines. When the tail lamp relay is
energized, power flows through
fuses 46 and 47, located in the IPDM E/R. Power then flows to th ...
Control buttons
The control buttons for the Bluetooth® Hands-Free
Phone System are located on the steering wheel.
PHONE/SEND
Press the button to initiate a
VR
session or answer an incoming call.
You can also use the button to
interrupt the system feedback and
give a command at once. See “List o ...