Nissan Altima 2007-2012 Service Manual: ECM branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).

- ECM

- Harness connector E30

- Harness connector M1

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of ECM.

2. Check the resistance between the ECM harness connector terminals.

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the ECM branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the ECM. Refer to the following.

• QR engine models for California: EC-144, "Diagnosis Procedure" • QR engine models expect for California: EC-673, "Diagnosis Procedure" • VQ engine models: EC-1175, "Diagnosis Procedure" Is the inspection result normal? YES (Present error)>>Replace the ECM. Refer to the following.

• QR engine models for California: EC-27, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement" • QR engine models except for California: EC-563, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement" • VQ engine models: EC-1051, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement" YES (Past error)>>Error was detected in the ECM branch line.

NO >> Repair the power supply and the ground circuit.

    Main line between dlc and abs circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and co ...

    A-BAG branch line circuit
    Diagnosis Procedure 1.CHECK AIR BAG DIAGNOSIS SENSOR UNIT Check the air bag diagnosis sensor unit. Refer to SRC-3, "Work Flow". Is the inspection result normal? YES >> Replace t ...

    Other materials:

    Normal operating condition
    Description AUDIO SYSTEM The majority of the audio troubles are the result of outside causes (bad CD, electromagnetic interference, etc.). Noise The following noise results from variations in field strength, such as fading noise and multi-path noise, or external noise from trains and oth ...

    P0643 Sensor power supply
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. TESTING CONDITION: Before performing the following proced ...

    Diagnosis system (BCM)
    Diagnosis Description BCM CONSULT-III FUNCTION CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the following for all sub system selecti ...