Nissan Altima 2007-2012 Service Manual: Engine start function symptoms

Symptom Table

Engine cannot be started with all keyfobs.

CAUTION: • Follow Trouble Diagnosis Flowchart referring to “SEC-411, "Work Flow"”. Determine malfunctioning condition before performing this diagnosis.

• Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis.

• Check systems shown in the “Diagnosis/service procedure” column in this order.

CONDITIONS OF VEHICLE (OPERATING CONDITIONS)

• Engine start function is ON when setting on CONSULT-III.

• Use keyfob with registered keyfob ID.

• One or more of keyfobs with registered keyfob ID is in the passenger compartment.

    Vehicle security system symptoms
    Symptom Table *: Check that the system is in the armed phase. ...

    Other materials:

    Multiport fuel injection system
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: This sensor is not used to control the engine system under normal conditions. *2: This signal is sent to the ECM via the CAN communication line. *3: ECM determines the start signal status by the signals of engine speed an ...

    Inspection and adjustment
    ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT Precaution for TCM and CVT Assembly Replacement CAUTION: • Check if new data (Unit ID) are entered correctly after replacing CVT assembly and erasing data in TCM. (Connect CONSULT-III, and then turn ignition switch OFF.) • When replacing CV ...

    B2602 shift position
    Description BCM confirms the shift position with the following 2 signals. • CVT selector lever • Speed signal from meter DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2602 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-433, "DTC ...