Nissan Altima Owners Manual: Floor mats
WARNING
To avoid potential pedal interference that may result in a collision or injury:
● NEVER place a floor mat on top of another floor mat in the driver front position.
● Use only genuine NISSAN floor mats specifically designed for use in your vehicle model. See your NISSAN dealer for more information.
● Properly position the mats in the floorwell using the floor mat positioning aid.
See Floor mat positioning aid in this section.
The use of genuine NISSAN floor mats can extend the life of your vehicle carpet and make it easier to clean the interior. Mats should be maintained with regular cleaning and replaced if they become excessively worn.
Floor mat positioning aid
This vehicle includes two driver’s side front floor mat brackets and one passenger’s side front floor mat bracket to help keep your floor mats in place.
Genuine NISSAN floor mats have been specially designed for your vehicle model. The driver’s side floor mat has two grommet holes incorporated in it and the passenger’s side has one grommet hole. Position each mat by placing the floor mat bracket hook through the floor mat grommet holes while centering the mat in the floorwell.
Periodically check to make certain the mats are properly positioned.
Air fresheners
Most air fresheners use a solvent that could affect
the vehicle interior. If you use an air freshener,
take the following precautions:
● Hanging-type air fresheners can cause permanent
disco ...
Seat belts
The seat belts can be cleaned by wiping them
with a sponge dampened in a mild soap solution.
Allow the belts to dry completely in the shade
before using them. See “Seat belt maintenance”
in ...
Other materials:
Audio unit (coupe)
Reference Value
TERMINAL LAYOUT
PHYSICAL VALUES - WITH BLUETOOTH
PHYSICAL VALUES - WITHOUT BLUETOOTH
Wiring Diagram - Coupe
...
P0448 Evap canister vent control valve
Description
The EVAP canister vent control valve is located on the EVAP canister
and is used to seal the canister vent.
This solenoid valve responds to signals from the ECM. When the
ECM sends an ON signal, the coil in the solenoid valve is energized.
A plunger will then move to seal the ca ...
Front wiper blade refill
Removal and Installation
REMOVAL
1. Remove the front wiper blade. Refer to WW-115, "FRONT WIPER BLADE :
Removal and Installation".
2. Hold the wiper blade refill lip at the end (A) of the front wiper
blade (1) with a suitable tool (B) as shown, and pull it firmly in
the direc ...