Nissan Altima Owners Manual: Seat belts

The seat belts can be cleaned by wiping them with a sponge dampened in a mild soap solution.

Allow the belts to dry completely in the shade before using them. See “Seat belt maintenance” in the “Safety – Seats, seat belts and supplemental restraint system” section of this manual.

WARNING

Do not allow wet seat belts to roll up in the retractor. NEVER use bleach, dye or chemical solvents to clean the seat belts, since these materials may severely weaken the seat belt webbing.

    Floor mats
    WARNING To avoid potential pedal interference that may result in a collision or injury: ● NEVER place a floor mat on top of another floor mat in the driver front position. ● Use only ...

    Corrosion protection
    ...

    Other materials:

    B26E1 No reception of engine status signal
    Description BCM receives the engine status signal from ECM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26E1 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-235, "DTC Logic". • If DTC B26E1 is displayed wi ...

    Front seat
    Exploded View DRIVER'S SEAT 1. Headrest 2. Headrest holder (locked) 3. Headrest holder (free) 4. Seatback board 5. Seatback assembly 6. Slide cover 7. Seat belt buckle 8. Seat harness 9. Seat cushion heater unit 10. Seat cushion 11. Seat trim 12. Front leg covers 13. Seat cushion fr ...

    P0131, P0151 A/F sensor 1
    Description The air fuel ratio (A/F) sensor 1 is a planar one-cell limit current sensor. The sensor element of the A/F sensor 1 is composed an electrode layer, which transports ions. It has a heater in the element. The sensor is capable of precise measurement = 1, but also in the lean and ...