Nissan Altima (L32) 2007-2012 Service Manual ≻ Exterior coupe ≻ On-vehicle repair ≻ Front grille

Nissan Altima (L32) 2007-2012 Service Manual: Front grille

Removal and Installation

1. Front bumper fascia

2. Front grille

3. License plate bracket

4. Fog lamp finisher (if equipped)

5. Fog lamp (if equipped)

A. Clip C101

Removal

1. Remove the front fender protectors RH and LH. Refer to EXT-19, "Removal and Installation".

2. Remove the engine under cover.

3. Remove the RH and LH side under covers.

4. Remove the front bumper fascia clips and screws, then remove the front bumper fascia.

5. Remove the fog lamp if equipped. Refer to EXL-256, "Removal and Installation".

6. Release the grille tabs from the front bumper fascia and remove the front grille.

Installation

Installation is in the reverse order of removal.

Rear bumper

Removal and Installation 1. Rear bumper side brackets 2. Rear bumper supports 3. Rear bumper reinforcement 4. Rear energy absorbing foam 5. Rear bumper fascia A. C205 push pin REMOVAL 1. R ...

Cowl top

Removal and Installation 1. Cowl top seal 2. Cowl top side trim covers 3. Cowl top foam blocks 4. Cowl top A. Clips REMOVAL 1. Remove both the RH and LH wiper arms. Refer to WW-116, "FRO ...

Other materials:

Corrosion protection
Most common factors contributing to vehicle corrosion Most vehicle corrosion is caused by: The accumulation of moisture-retaining dirt and debris in body panel sections, cavities, and other areas. Damage to paint and other protective coatings caused by gravel and stone chips or minor traffic ...

Warning/Indicator lights (other)
For additional information on warnings and indicators, see "Vehicle information display-5 inch (13 cm) Type A" or "Vehicle information display 7 inch (18 cm) Type B". Automatic brake hold indicator light (white/green) (if so equipped) The automatic brake hold indicator light (white) illuminates whe ...

Rear-facing child restraint installation using the seat belts
WARNING The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being properly secured. The restraint could tip over or be loose and cause injury to a child in a sudden stop o ...