Nissan Altima 2007-2012 Service Manual: Cowl top

Removal and Installation

1. Cowl top seal

2. Cowl top side trim covers

3. Cowl top foam blocks

4. Cowl top

A. Clips

REMOVAL

1. Remove both the RH and LH wiper arms. Refer to WW-116, "FRONT WIPER ARMS : Removal and Installation".

2. Remove the cowl top side trim covers.

3. Remove the cowl top foam blocks.

4. Remove the cowl top clips and remove the cowl top.

INSTALLATION

Installation is in the reverse order of removal.

    Front grille
    Removal and Installation 1. Front bumper fascia 2. Front grille 3. License plate bracket 4. Fog lamp finisher (if equipped) 5. Fog lamp (if equipped) A. Clip C101 Removal 1. Remove the fron ...

    Fender protector
    Removal and Installation 1. Fender protector 2. Fender protector side cover A. J-clips B. Clips C. Center mudguard screw a. Sheet metal nut REMOVAL 1. Remove the engine under cover. Refer ...

    Other materials:

    Stall test
    Inspection and Judgment INSPECTION 1. Inspect the amount of engine oil. Replenish the engine oil if necessary. 2. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80°C (122 to 176°F). Inspect the amount of CVT fluid. Replenish if necessary. 3. ...

    P2101 electric throttle control function
    Description Electric throttle control actuator consists of throttle control motor, throttle position sensor, etc. The throttle control motor is operated by the ECM and it opens and closes the throttle valve. The current opening angle of the throttle valve is detected by the throttle po ...

    P0075 ivt control solenoid valve
    Description Intake valve timing control solenoid valve is activated by ON/OFF pulse duty (ratio) signals from the ECM. The intake valve timing control solenoid valve changes the oil amount and direction of flow through intake valve timing control unit or stops oil flow. The longer pulse w ...