Nissan Altima 2007-2012 Service Manual: Front passenger side power window alone does not operate

Diagnosis Procedure

1. CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH

Check power window and door lock/unlock switch RH.

Refer to PWC-108, "FRONT POWER WINDOW SWITCH : Component Function Check".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning parts.

2. CHECK FRONT POWER WINDOW MOTOR RH CIRCUIT

Check front power window motor RH circuit.

Refer to PWC-116, "PASSENGER SIDE : Component Function Check".

Is the inspection result normal? YES >> Inspection end.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Driver side power window alone does not operate
    Diagnosis Procedure 1. CHECK FRONT POWER WINDOW MOTOR LH Check front power window motor LH. Refer to PWC-114, "DRIVER SIDE : Component Function Check". Is the inspection result norma ...

    Rear lh side power window alone does not operate
    Diagnosis Procedure 1. CHECK REAR POWER WINDOW SWITCH LH Check rear power window switch LH. Refer to PWC-110, "REAR POWER WINDOW SWITCH : Component Function Check". Is th e inspectio ...

    Other materials:

    ASCD Brake switch
    Description When the brake pedal is depressed, ASCD brake switch is turned OFF and stop lamp switch is turned ON. ECM detects the state of the brake pedal by this input of two kinds (ON/OFF signal). Refer to EC-603, "System Description" for the ASCD function. Component Functio ...

    Drive belts
     Checking Drive Belts WARNING: Inspect the drive belt only when the engine is stopped. NOTE: On vehicles not equipped with A/C, there is an idler pulley in the position for the drive belt routing. • Make sure that the stamp mark of drive belt auto-tensioner is within the usable ...

    BCM
    Diagnosis Procedure 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuse or fusible link are blown. Is the fuse or fusible link blown? YES >> Replace the blown fuse or fusible link after repairing the affected circuit. NO >> GO TO 2 2. CHECK POWER SUPPLY CIRCUIT 1. ...