Nissan Altima (L32) 2007-2012 Service Manual: Rear lh side power window alone does not operate

Diagnosis Procedure

1. CHECK REAR POWER WINDOW SWITCH LH

Check rear power window switch LH.

Refer to PWC-110, "REAR POWER WINDOW SWITCH : Component Function Check".

Is th e inspection result normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning parts.

2. CHECK REAR POWER WINDOW MOTOR LH

Check rear power window motor LH.

Refer to PWC-117, "REAR LH : Component Function Check".

Is th e inspection result normal? YES >> Inspection end.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Front passenger side power window alone does not operate
    Diagnosis Procedure 1. CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH Check power window and door lock/unlock switch RH. Refer to PWC-108, "FRONT POWER WINDOW SWITCH : Component Function ...

    Rear rh side power window alone does not operate
    Diagnosis Procedure 1. CHECK REAR POWER WINDOW SWITCH RH Check rear power winodw switch RH. Refer to PWC-110, "REAR POWER WINDOW SWITCH : Component Function Check". Is the inspection ...

    Other materials:

    Changing engine coolant
    A NISSAN dealer can change the engine coolant. The service procedure can be found in the NISSAN Service Manual. Improper servicing can result in reduced heater performance and engine overheating. WARNING ● To avoid the danger of being scalded, never change the coolant when the engin ...

    P1778 step motor - function
    Description • The step motor's 4 aspects of ON/OFF change according to the signal from TCM. As a result, the flow of line pressure to primary pulley is changed and pulley ratio is controlled. • This diagnosis item is detected when electrical system is OK, but mechanical system is NG. ...

    Fender protector
    Removal and Installation 1. Fender protector 2. Fender protector side cover A. J-clips B. Clips C. Center mudguard screw a. Sheet metal nut REMOVAL 1. Remove the engine under cover. Refer to EXT-13, "Removal and Installation". 2. Remove the screw from center mudguard. 3 ...