Nissan Altima Owners Manual: Fuel gauge

The gauge indicates the approximate fuel level


The gauge indicates the approximate fuel level in the tank.

The gauge may move slightly during braking, turning, acceleration, or going up or down hills.

The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.

The low fuel warning light comes on when the amount of fuel in the tank is getting low.

Refill the fuel tank before the gauge registers 0 (Empty).

The fuel-filler door is indicates that the
fuel-filler door is located on the driver’s side of the vehicle.

CAUTION

● If the vehicle runs out of fuel, the Malfunction Indicator Light (MIL) may
Malfunction Indicator Light (MIL) may come on. Refuel as soon as possible.

After a few driving trips. the light
light should turn off. If the light remains on after a few driving trips, have the vehicle inspected by a NISSAN dealer.

● For additional information, see “Malfunction Indicator Light (MIL)” later in this section.

    Engine coolant temperature gauge
    The gauge indicates the engine coolant temperature. The engine coolant temperature is within the normal range 1 when the gauge needle points within the zone shown in the illustration. The en ...

    Compass display (if so equipped)
    This unit measures terrestrial magnetism and indicates the direction of the vehicle’s heading. With the ignition switch placed in the ON position, press the button as described in the chart ...

    Other materials:

    B2560 starter control relay
    Description Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N or P position and the steering is locked or unlocked. It is installed in parallel with the starter relay. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2560 is displayed with DTC U10 ...

    B2191, P1615 difference of key
    Description Performs ID verification through BCM and Intelligent Key when push-button ignition switch is pressed. Prohibits the release of steering lock or start of engine when an unregistered ID of Intelligent Key is used. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.P ...

    P1553 Battery current sensor
    Description The power generation voltage variable control enables fuel consumption to be decreased by reducing the engine load which is caused by the power generation of the generator. The battery current sensor is installed to the battery cable at the negative terminal. The sensor measures t ...