Nissan Altima Owners Manual: Hazard warning flasher switch
Push the switch on to warn other drivers when you must stop or park under emergency conditions.
All turn signal lights flash.
WARNING
● If stopping for an emergency, be sure to move the vehicle well off the road.
● Do not use the hazard warning flashers while moving on the highway unless unusual circumstances force you to drive so slowly that your vehicle might become a hazard to other traffic.
● Turn signals do not work when the hazard warning flasher lights are on.
The flashers will operate with the ignition switch placed in any position.
Some state laws may prohibit the use of the hazard warning flasher switch while driving.
Emergency engine shut off
To shut off the engine in an emergency situation
while driving, perform the following procedure:
– Rapidly push the push-button ignition switch 3
consecutive times in less than 1.5 seconds, or
â ...
Flat tire
...
Other materials:
Glass
When cleaning the rear window, it may be easier
to clean if the high-mounted stop light (if so
equipped) is removed first.
Be careful when removing the high-mounted
stop light to reduce the risk of damaging the
high-mounted stop light wires.
To remove the high-mounted stop light:
1 Push ...
P1800 Vias control solenoid valve 1
Description
The VIAS control solenoid valve 1 cuts the intake manifold vacuum signal for
power valve 1 control. It
responds to ON/OFF signals from the ECM. When the solenoid is OFF, the vacuum
signal from the intake
manifold is cut. When the ECM sends an ON signal the coil pulls the plunger
...
Driver air bag module
Exploded View
1. Steering switch connector
2. Steering switch ground connector
3. Steering switches
4. Driver air bag module
5. Driver air bag module connectors
6. Side lid (RH/LH)
A. Steering switch screw
B. Driver air bag module bolt (RH/LH)
Removal and Installation
REMOVAL
CAUTION:
...