Nissan Altima 2007-2012 Service Manual: High-pressure flexible hose

Removal and Installation for High-Pressure Flexible Hose

QR25DE

Removal

1. Discharge the refrigerant. Refer to HA-32, "HFC-134a (R-134a) Service Procedure".

2. Reposition the power steering reservoir out of the way without disconnecting the hose.

3. Reposition the engine coolant reservoir out of the way without disconnecting the hose.

4. Remove the high-pressure flexible hose. Refer to HA-31, "Component".

CAUTION: Cap or wrap the joint of the hose with a suitable material such as vinyl tape to avoid the entry of contaminants.

Installation

Installation is in the reverse order of removal.

CAUTION: • Replace the O-ring of the high-pressure flexible hose with a new one, then apply A/C oil to it for installation.

• After charging the refrigerant, check for leaks. Refer to HA-25, "Checking of Refrigerant Leaks".

VQ35DE

Removal

1. Discharge the refrigerant. Refer to HA-32, "HFC-134a (R-134a) Service Procedure".

2. Remove the engine cooling fan and shroud assembly. Refer to CO-40, "Removal and Installation".

3. Reposition the power steering reservoir out of the way without disconnecting the hose.

4. Reposition the engine coolant reservoir out of the way without disconnecting the hose.

5. Remove the high-pressure flexible hose. Refer to HA-31, "Component".

CAUTION: Cap or wrap the joint of the hose with a suitable material such as vinyl tape to avoid the entry of contaminants.

Installation

Installation is in the reverse order of removal.

CAUTION: • Replace the O-ring of the high-pressure flexible hose with a new one, then apply A/C oil to it for installation.

• After charging the refrigerant, check for leaks. Refer to HA-25, "Checking of Refrigerant Leaks".

    Low-pressure pipe
    Removal and Installation for Low-Pressure Pipe QR25DE Removal 1. Discharge the refrigerant. Refer to HA-24, "HFC-134a (R-134a) Service Procedure". 2. Remove the strut tower bar. Ref ...

    High-pressure pipe
    Removal and Installation for High-Pressure Pipe QR25DE Removal 1. Discharge the refrigerant. Refer to HA-24, "HFC-134a (R-134a) Service Procedure". 2. Remove the strut tower bar. Re ...

    Other materials:

    P1705 throttle position sensor
    Description Electric throttle control actuator consists of throttle control motor, accelerator pedal position sensor, throttle position sensor etc. The actuator sends a signal to the ECM, and ECM sends the signal to TCM with CAN communication. DTC Logic DTC DETECTION LOGIC DTC CONFIRMAT ...

    Auto operation does not operate but manual operates normally (passenger side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement". Is the inspection result normal? YES >> GO TO 2 NO >> Repair or replace the mal ...

    On-vehicle repair
    EVAP CANISTER Exploded View 1. EVAP control system pressure sensor 2. EVAP canister 3. O-ring 4. EVAP canister vent control valve 5. O-ring Removal and Installation REMOVAL 1. Lift up the vehicle. 2. Remove EVAP canister fixing bolt. 3. Remove EVAP canister. NOTE: The EVAP canis ...