Nissan Altima (L32) 2007-2012 Service Manual: Ignition timing
Description
This describes how to check the ignition timing. For the actual procedure,
follow the instructions in “BASIC
INSPECTION”.
IGNITION TIMING : Special Repair Requirement
1.CHECK IGNITION TIMING
1. Attach timing light to No. 1 igniton coil (1) wire as shown.
2. Check ignition timing.
1 : Timing indicator
>> INSPECTION END
Description
This describes how to check the idle speed. For the actual procedure, follow
the instructions in “BASIC
INSPECTION”.
IDLE SPEED : Special Repair Requirement
1.CHECK IDLE S ...
Description
VIN Registration is an operation to registering VIN in ECM. It must be
performed each time ECM is replaced.
NOTE:
Accurate VIN which is registered in ECM may be required for Inspec ...
Other materials: Engine compartment check locations
2.0L 4 cylinder (KR20DDET engine model)
Engine coolant reservoir
Drive belt location
Engine oil filler cap
Brake fluid reservoir
Battery
Fuse/Fusible link box
Air cleaner
Radiator cap
Engine oil dipstick
Windshield-washer fluid reservoir
Refer to the page number indicated in
parenth ...
Front power seat adjustment
(if so equipped)
Operating tips
The power seat motor has an auto-reset
overload protection circuit. If the motor
stops during operation, wait 30 seconds
then reactivate the switch.
Do not operate the power seat switch for
a long period of time when the engine is
off. This will discharge the battery.
For add ...
Vehicle information display warnings
and indicators
The following messages may appear in
your vehicle information display.
Engine start operation for
Intelligent Key system (if
I-Key battery level is low)
This indicator appears when the battery of
the Intelligent Key is low and when the Intelligent
Key system and the vehicle are not
communicating no ...