Nissan Altima (L32) 2007-2012 Service Manual ≻ Engine control system QR25DE for california ≻ Basic inspection ≻ Vin registration

Nissan Altima (L32) 2007-2012 Service Manual: Vin registration

Description

VIN Registration is an operation to registering VIN in ECM. It must be performed each time ECM is replaced.

NOTE: Accurate VIN which is registered in ECM may be required for Inspection & Maintenance (I/M)

VIN REGISTRATION : Special Repair Requirement

1.CHECK VIN

Check the VIN of the vehicle and note it. Refer toGI-23, "Identification Number - Coupe" or GI-22, "Identification Number - Sedan".

>> GO TO 2.

2.PERFORM VIN REGISTRATION

1. Turn ignition switch ON and engine stopped.

2. Select “VIN REGISTRATION” in “WORK SUPPORT” mode.

3. Follow the instruction of CONSULT-III display.

>> END

Ignition timing

Description This describes how to check the ignition timing. For the actual procedure, follow the instructions in “BASIC INSPECTION”. IGNITION TIMING : Special Repair Requirement 1.CHECK IG ...

Accelerator pedal released position learning

Description Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor out ...

Other materials:

USB (Universal Serial Bus) Connection Port
Type-A. Connecting a device to the USB Connection Port WARNING Do not connect, disconnect, or operate the USB device while driving. Doing so can be a distraction. If distracted you could lose control of your vehicle and cause an accident or serious injury. CAUTION To avoid damage and loss of f ...

Front power seat adjustment (if so equipped)
Operating tips The power seat motor has an auto-reset overload protection circuit. If the motor stops during operation, wait 30 seconds then reactivate the switch. Do not operate the power seat switch for a long period of time when the engine is off. This will discharge the battery. For add ...

Difference between predicted and actual distances
The displayed guidelines and their locations on the ground are for approximate reference only. Objects on uphill or downhill surfaces or projecting objects will be actually located at distances different from those displayed in the monitor relative to the guidelines (refer to illustrations). When in ...