Nissan Altima (L32) 2007-2012 Service Manual ≻ Engine control system QR25DE except for california ≻ Inspection and adjustment ≻ Ignition timing

Nissan Altima (L32) 2007-2012 Service Manual: Ignition timing

Description

This describes how to check the ignition timing. For the actual procedure, follow the instructions in “BASIC INSPECTION”.

Special Repair Requirement

1.CHECK IGNITION TIMING

1. Attach timing light to No. 1 igniton coil (1) wire as shown.

2 : Timing light

2. Check ignition timing.

1 : Timing indicator

>> INSPECTION END

Idle speed

Description This describes how to check the idle speed. For the actual procedure, follow the instructions in “BASIC INSPECTION”. Special Repair Requirement 1.CHECK IDLE SPEED Check idle s ...

Vin registration

Description VIN Registration is an operation to registering VIN in ECM. It must be performed each time ECM is replaced. NOTE: Accurate VIN which is registered in ECM may be required for Inspec ...

Other materials:

Seat belt warning light and chime
The driver and front passenger seat is equipped with an enhanced seat belt reminder function. A visual and audible alert will operate at speeds of approximately 9 mph (15 km/h) or more under the following conditions: If the driver seat belt is not fastened. The front passenger’s seat belt is ...

Heated steering wheel switch (if so equipped)
Push the heated steering wheel switch to warm the steering wheel after the ignition switch is placed in the ON position. The indicator light will come on. If the surface temperature of the steering wheel is below 68ºF (20ºC), the system will heat the steering wheel and cycle off and on to mainta ...

Settings
The setting mode allows you to change the information displayed in the vehicle information display. It also allows you to change vehicle functions: VDC Driver Assistance Clock Meter Settings Vehicle Settings Maintenance Alarm Tire Pressures Unit Language Factory Reset VDC The VDC Settin ...