Nissan Altima (L32) 2007-2012 Service Manual ≻ Engine control system QR25DE except for california ≻ Inspection and adjustment ≻ Vin registration

Nissan Altima (L32) 2007-2012 Service Manual: Vin registration

Description

VIN Registration is an operation to registering VIN in ECM. It must be performed each time ECM is replaced.

NOTE: Accurate VIN which is registered in ECM may be required for Inspection & Maintenance (I/M)

Special Repair Requirement 1.CHECK VIN

Check the VIN of the vehicle and note it. Refer to GI-22, "Identification Number - Sedan" or GI-23, "Identification Number - Coupe".

>> GO TO 2.

2.PERFORM VIN REGISTRATION

1. Turn ignition switch ON and engine stopped.

2. Select “VIN REGISTRATION” in “WORK SUPPORT” mode.

3. Follow the instruction of CONSULT-III display.

>> END

Ignition timing

Description This describes how to check the ignition timing. For the actual procedure, follow the instructions in “BASIC INSPECTION”. Special Repair Requirement 1.CHECK IGNITION TIMING 1. A ...

Accelerator pedal released position learning

Description Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor outp ...

Other materials:

Vehicle information display warnings and indicators
The following messages may appear in your vehicle information display. Place the key near the start switch This indicator appears when the battery of the Intelligent Key is low and when the Intelligent Key system and the vehicle are not communicating normally. If this appears, touch the ignition s ...

Operating range
The Intelligent Key functions can only be used when the Intelligent Key is within the specified operating range from the request switch (if so equipped) 1. When the Intelligent Key battery is discharged or strong radio waves are present near the operating location, the Intelligent Key system’s op ...

Programming HomeLink for Canadian customers and gate openers
Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of transmission - which may not be long enough for HomeLink to pick up the signal during training. Similar to this Canadian law, some U.S. gate operators are designed to "timeout" in the same mann ...