Nissan Altima (L32) 2007-2012 Service Manual ≻ Ventilation system ≻ On-vehicle repair ≻ Intake door motor

Nissan Altima (L32) 2007-2012 Service Manual: Intake door motor

Removal and Installation

REMOVAL

1. Remove the instrument panel assembly. Refer to VTL-14, "Removal and Installation".

2. Disconnect the intake door motor connector (1).

3. Remove the intake door motor screws (A) and remove intake door motor from the blower unit.

INSTALLATION

Installation is in the reverse order of removal.

Fan control amplifier

Removal and Installation The fan control amplifier is part of the blower motor. Refer to VTL-15, "Removal and Installation". ...

Mode door motor

Removal and Installation REMOVAL 1. Remove the combination meter. Refer to MWI-176, "Removal and Installation". 2. Remove the BCM (2). Refer to BCS-96, "Removal and Installation ...

Other materials:

BSW system limitations
WARNING Listed below are the system limitations for the BSW system. Failure to operate the vehicle in accordance with these system limitations could result in serious injury or death. The BSW system cannot detect all vehicles under all conditions. The radar sensors may not be able to detect and ...

Readiness for Inspection/Maintenance (I/M) test
WARNING A vehicle equipped with All-Wheel Drive (AWD) should never be tested using a two wheel dynamometer (such as the dynamometers used by some states for emissions testing), or similar equipment. Make sure you inform the test facility personnel that your vehicle is equipped with AWD before it is ...

Vehicle information display warnings and indicators
The following messages may appear in your vehicle information display. Place the key near the start switch This indicator appears when the battery of the Intelligent Key is low and when the Intelligent Key system and the vehicle are not communicating normally. If this appears, touch the ignition s ...