Nissan Altima (L32) 2007-2012 Service Manual: Fan control amplifier
Removal and Installation
The fan control amplifier is part of the blower motor. Refer to VTL-15, "Removal and Installation".
Blower motor
Removal and Installation REMOVAL 1. Remove the glove box. Refer to IP-12, "Removal and Installation". 2. Disconnect the blower motor connector (1). 3. Remove the three blower motor ...Intake door motor
Removal and Installation REMOVAL 1. Remove the instrument panel assembly. Refer to VTL-14, "Removal and Installation". 2. Disconnect the intake door motor connector (1). 3. Remove ...Other materials:
P0447 evap canister vent control
valve
Description
The EVAP canister vent control valve is located on the EVAP canister
and is used to seal the canister vent.
This solenoid valve responds to signals from the ECM. When the
ECM sends an ON signal, the coil in the solenoid valve is energized.
A plunger will then move to seal the ca ...
Door outside molding
Removal and Installation
1. Front door outside molding
2. Rear door outside molding
Front Door Outside Molding
Removal
1. Open the front door window fully.
2. Remove the side view mirror. Refer to MIR-19, "Removal and Installation".
3. Lift and twist from rear side, disconn ...
B261a push-button ignition switch
Description
IPDM E/R transmits the push-button ignition switch status via CAN
communication to BCM. BCM receives
push-button ignition switch status by hardwire input. BCM compares the 2 signals
for mismatch.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B261A is displayed with DTC U1000 ...