Nissan Altima 2007-2012 Service Manual: Intelligent key system/engine start function symptoms

Symptom Table

Engine cannot be started with all Intelligent Keys.

CAUTION: • Follow Trouble Diagnosis Flowchart referring to “SEC-10, "Work Flow"”. Determine malfunctioning condition before performing this diagnosis.

• Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis.

• Check systems shown in the “Diagnosis/service procedure” column in this order.

CONDITIONS OF VEHICLE (OPERATING CONDITIONS)

• Engine start function is ON when setting on CONSULT-III.

• Use Intelligent Key with registered Intelligent Key ID.

• One or more of Intelligent Keys with registered Intelligent Key ID is in the passenger compartment.

    Vehicle security system symptoms
    Symptom Table *: Check the system is in the armed phase. ...

    Other materials:

    B2607 steering lock relay
    Description BCM requests to IPDM E/R to supply power to electronic steering column lock. IPDM E/R sends status of electronic steering column lock back to BCM. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2607 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U100 ...

    P1777 step motor
    Description The step motor changes the step with turning 4 coils ON/OFF according to the signal from TCM. As a result, the flow of line pressure to primary pulley is changed and pulley ratio is controlled DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive v ...

    Magnet clutch
    Description SYSTEM DESCRIPTION Front air control controls A/C compressor operation by ambient temperature and signal from ECM. Low Temperature Protection Control Front air control will turn the A/C compressor ON or OFF as determined by a signal detected by ambient sensor. When ambient te ...