Nissan Altima Owners Manual: Interior light
1 The interior light can be turned ON regardless of door position. The light will go off after a period of time unless the ignition switch is placed in the ON position when any door is opened.
2 The interior lights can be set to operate when the doors are opened. To turn off the interior lights when a door open, push the switch, the interior lights will not illuminate, regardless of door position.
The lights will go off when the ignition switch is placed in the ON position, or the driver’s door is closed and locked. The lights will also go off after a period of time when the doors are open.
NOTE:
The step lights illuminate when the driver and passenger doors are opened regardless of the interior light switch position.
These lights will turn off automatically after a period of time while doors are open to prevent the battery from becoming discharged.
CAUTION
Do not use for extended periods of time with the engine stopped. This could result in a discharged battery.
CONSOLE LIGHT
The console light will turn on whenever the parking lights or headlights are illuminated.
Moonroof (if so equipped)
AUTOMATIC MOONROOF
switch is placed in the ON position. The automatic
moonroof is operational for a period of time,
even if the ignition switch is placed in the ACC or
OFF position. If the drive ...
Personal Lights
Rear personal lights
To turn the rear personal lights on, press the
switch. To turn them off, press the switch again. ...
Other materials:
BCM branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the BCM for damage, bend and loose
connection (unit side and
connector side).
Is the inspection result normal?
Y ...
Rear-facing child restraint installation using LATCH
Refer to all Warnings and Cautions in the “Child
Safety” and “Child Restraint” sections before installing
a child restraint.
Follow these steps to install a rear-facing child
restraint using the LATCH system:
1. Position the child restraint on the seat. Always
follow the child restra ...
Parking, license plate and tail
lamps
System Diagram
System Description
• BCM (Body Control Module) controls parking, license plate and tail lamps
operation.
• IPDM E/R (Intelligent Power Distribution Module Engine Room) operates parking,
license plate and tail
lamps according to CAN communication signals from BCM.
Co ...