Nissan Altima (L32) 2007-2012 Service Manual: Key slot
Diagnosis Procedure
1.CHECK KEY SLOT POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect key slot connector.
3. Check voltage between slot connector and ground.
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace key slot power supply circuit.
2.CHECK KEY SLOT GROUND CIRCUIT
Check continuity between key slot connector and ground.
Is the inspection result normal?
YES >> GO TO 3
NO >> Repair or replace key slot ground circuit.
3.CHECK INTERMITTENT INCIDENT
Refer to GI-42, "Intermittent Incident".
>> Inspection End.
Diagnosis Procedure
1. CHECK FUSES AND FUSIBLE LINK
Check that the following IPDM E/R fuses or fusible link are not blown.
Is the fuse blown?
YES >> Replace the blown fuse or fusible link ...
Description
Blinks when Intelligent Key insertion is required.
Component Function Check
Check key slot illumination (“KEY SLOT ILLUMI”) Active Test mode.
Is the inspection result normal? ...
Other materials: LDW system operation
For vehicles with the 7 inch (18 cm) display
The LDW system provides a lane departure
warning function when the vehicle is
driven at speeds of approximately 37 mph
(60 km/h) and above and the lane markings
are clear. When the vehicle approaches
either the left or the right side
of the traveling lan ...
MOD system operation
The MOD system will turn on automatically
under the following conditions:
When the shift lever is in the R (Reverse)
position.
When the CAMERA button is pressed to
activate the camera view on the display.
When vehicle speed decreases below approximately
6 mph (10 km/h) and the
camera screen ...
Moving Object Detection (MOD)
(if so equipped)
CAMERA button
WARNING
Failure to follow the warnings and instructions
for proper use of the Moving
Object Detection (MOD) system could
result in serious injury or death
The MOD system is not a substitute
for proper vehicle operation and is
not designed to prevent contact with
objects surrou ...