Nissan Altima (L32) 2007-2012 Service Manual: License lamp finisher
Removal and Installation
1. License lamp finisher
REMOVAL
1. Remove the trunk lid finisher (if equipped). Refer to INT-23, "Removal and
Installation".
2. Remove the license lamp finisher nuts.
3. Remove license lamp finisher by pulling toward the rear, then disconnect the
trunk request switch connector.
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
1. Body side outer panel
2. Windshield
3. Roof
REMOVAL
1. Lift and twist the roof side molding up from the rear edge.
2. Disconnect the roof side molding from th ...
Other materials: System maintenance
The two radar sensors 1 for the BSW and
RCTA systems are located near the rear
bumper. Always keep the area near the radar
sensors clean.
The radar sensors may be blocked by temporary
ambient conditions such as splashing
water, mist or fog.
The blocked condition may also be caused
by objects such ...
RearView Monitor (if so equipped)
CAMERA or DISP button
WARNING
Failure to follow the warnings and instructions
for proper use of the Rear-
View Monitor system could result in
serious injury or death.
RearView Monitor is a convenience
feature and is not a substitute for
proper backing. Always turn and look
out the windo ...
ProPILOT Assist switches
DISTANCE switch:
Long
Middle
Short
RES+ switch:
Resumes set speed or increases speed
incrementally
CANCEL switch:
Deactivates the ProPILOT Assist system
ProPILOT Assist switch:
Turns the ProPILOT Assist system on or off
SET- switch:
Sets desired cruise speed or reduces
speed i ...
Roof side molding
Exterior sedan