Nissan Altima (L32) 2007-2012 Service Manual ≻ Exterior coupe ≻ On-vehicle repair ≻ Roof side molding

Nissan Altima (L32) 2007-2012 Service Manual: Roof side molding

Removal and Installation

1. Body side outer panel

2. Windshield

3. Roof

REMOVAL

1. Lift and twist the roof side molding up from the rear edge.

2. Disconnect the roof side molding from the clips, and remove the roof side molding.

INSTALLATION

Installation is in the reverse order of removal.

• Engage the roof molding into the clips starting at the rear.

Door outside molding

Removal and Installation 1. Front door outside molding 2. Front door Door Outside Molding Removal 1. Open the front door window fully. 2. Remove the side view mirror. Refer to MIR-19, &quo ...

License lamp finisher

Removal and Installation 1. License lamp finisher REMOVAL 1. Remove the trunk lid finisher (if equipped). Refer to INT-23, "Removal and Installation". 2. Remove the license lamp fi ...

Other materials:

Rear Cross Traffic Alert (RCTA)
WARNING Failure to follow the warnings and instructions for proper use of the RCTA could result in serious injury or death. The RCTA system is not a replacement for proper driving procedures and is not designed to prevent contact with vehicles or objects. When backing out of a parking space, a ...

Driving safety precautions
Your NISSAN is designed for both normal and off-road use. However, avoid driving in deep water or mud as your NISSAN is mainly designed for leisure use, unlike a conventional off-road vehicle. Remember that 2-Wheel Drive (2WD) models are less capable than All-Wheel Drive (AWD) models for rough road ...

Manual shift mode (if so equipped)
When the shift lever is in the D (Drive) position and the drive sport mode switch is pushed, the transmission is ready for the manual shift mode. Shift ranges can be selected manually by pulling the right-side or left-side paddle shifter. When shifting up, pull the right side paddle shifter (+) B. ...